Based in the United Kingdom, we offer a professional regrind and recover service to companies all over the world. Fast competitive turnaround for the strip and recovery of Strand Pelletizer feed rollers. We also re-grind solid rotors and cutters with bolt on blades, all rotors are ground to ensure the maximum lifespan of the cutter and all rotor teeth are ground to the existing helix angles.
Give our team a call to discuss your requirements or use the contact form to get in touch.
PELLETISER FEED ROLLER RECOVER
We offer a fast competitive turnaround for the strip and recovery of Strand Pelletizer feed rollers all our feed rollers are covered in Carboxilate nitrile to 75 shore hardness, This is the best all round compound for Pelletiser upper feed rolls this material has a good balance of durability and temperature resistance.
All shafts are prepared prior to covering to ensure the covering is fully bonded to the shaft this application ensures the feed roll rubber does not break away from the shaft in production.
Carboxilate Nitrile
Excellent abrasive and toughness resistance
Good chemical resistance
This compound is used where high abrasion and toughness resistance is paramount.
Hardness 75 Shore +/-3
Tensile strength 15.2 MPa
Continuous temperature resistance 110 degree C
Abrasive resistance 125 mm3
We can recover any feed roll from any manufacture of Pelletiser
- Accrapak
- Cumberland
- Maag
- Scheer
- Conair
If you have any applications that require a different material we can also offer PU, Hypalon or Viton but from experience we believe Carboxilate nitrile is the best for most Pelletizing applications
ROTOR REGRINDS
We can re-grind solid rotors and also cutters with bolt on blades all rotors are ground to ensure the maximum lifespan of the cutter all rotor teeth are ground to the existing helix angles we never grind cutters cylindrically this significantly reduces the life span of the cutter.
We can also regrind granulator knifes and stationary blades
Materials include
- M2
- D2
- Tungsten Carbide
- Stellite tipped rotors
- Heat treated CSM materials
Maximum rotor Length is 375mm in length
Maximum rotor Diameter is 250mm diameter
Maximum loose knife length is 250mm diameter
Typical Pelletiser rotors
- Accrapak
- Cumberland
- Maag
- Scheer
- Conair
